More photos Mitsubishi RVR
1991 Mitsubishi RVR driving shaft making clapping noise problems in Malaysia
| Date: | April 25, 2013, 9:09 am | |
| Name: | Elges | |
| Location: | Malaysia, Sarawak, Kuching | |
| Vehicle: | Mitsubishi RVR | |
| Year: | 1991 | |
| Modification: | RVR X | |
| General comments: | Been sending the car to workshop but no permanent solution, after a week out of garage the Driving Shaft makes noise again. | |
| Problems: | The Driving Shaft[end coupling] makes clapping noises when driving or reversing and sound like clapping cymbal was really a nuisance. | |
| Previous car: | Mitshubishi Super Touring | |
| Contact: | show contact | |
Photo Mitsubishi RVR | ||
 | ||
Suggest a Solution
| July 14, 2013, 2:25 am from: eric.tabaldo@gmail.com |
| i had the same problem with my 1995 rvr, i just replaced the torn connection plate between the engine and transmission and noise gone.. |
| June 16, 2015, 12:44 pm from: george |
| I replace my clutch and when starting the car it sound ok but when I accelerate the engin,there is knocking nose after the acceleration I thougt the nose was caming from balancershaft but am not realy sure. |
| Contact: show contact |
| June 16, 2015, 12:45 pm from: george |
| I replace my clutch and when starting the car it sound ok but when I accelerate the engin,there is knocking nose after the acceleration I thougt the nose was caming from balancershaft but am not realy sure. |
| Contact: show contact |
Updated on April 20, 2025