More photos Toyota Mark II
2000 Toyota Mark II engine check sign appearing on dash board problems in Uganda
Date: | November 11, 2016, 4:37 am | |
Name: | Suzan Engwenyu | |
Location: | Uganda, Kampala | |
Vehicle: | Toyota Mark II | |
Year: | 2000 | |
General comments: | Can someone help me out for I am really frustrated and scared of driving this vehicle.. I have taken the car for diagnosis in one of the best garages in town but they seem not to detect what the problem is. Can some one help please???? thank you so much in advance. cheers. God bless. | |
Problems: | I bought Toyota Mark 11 in May 2016 this year and it has been running well. Suddenly, its been one month now when the Engine check sign begins popping on the dash board. This normally occurs when am in the jam and the car is in slow motion. Each time the engine check sign pops up, the steering wheel gets so hard, the car runs out of power and it stalls suddenly. So I have to restart the engine in order for the car to re- start. This used to happen once in a while but the frequency of this occurrence is increasing and I find it so so strange. This vehicle is of VVTI Engine. | |
Contact: | show contact |
Suggest a Solution
November 20, 2016, 8:58 am from: jupiter cheembo |
My car not starting on and on dushboard ingine check is showing what could be the problem |
Contact: show contact |
November 22, 2016, 1:50 pm from: Joe - UG |
I was doing some reading about the 1G-FE engine (which is the one that powers Mark IIs) and it seems to be quite fragile especially the 98 model. From what i have read, it could be an oil pressure sensor issue causing this. Have someone look at that. More here http://mywikimotors.com/toyota-1g. Good luck! |
December 26, 2016, 7:57 pm from: ignie |
Engine check sign begins popping on the dash board. This normally occurs when am in the jam and the car is in slow motion. Each time the engine check sign pops up, the steering wheel gets so hard, the car runs out of power and it stalls suddenly. So I have to restart the engine in order for the car to re- start. This used to happen once in a while but the frequency of this occurrence is increasing and I find it so so strange. This vehicle is of VVTI Engine. |
Contact: show contact |
December 29, 2016, 2:34 am from: sydney musonda |
replace the vvti solenoid sensor your car will be fine i have that experience before on my 1g fe vvti engine. |
Contact: show contact |
January 21, 2017, 11:38 am from: wamala abdul |
I just need a solution to that effect |
Contact: show contact |
January 21, 2017, 11:47 am from: wamala abdul |
The check engine light is on and the gearbox does not respond when I accelerate so please I need your assistance |
Contact: show contact |
May 4, 2017, 9:34 am from: Mulindwa yasin |
If the car stalls, then you shud check the spark plug wires, that is misfire |
Contact: show contact |
May 4, 2017, 9:35 am from: Mulindwa yasin |
If the car stalls, then you shud check the spark plug wires, that is misfire |
Contact: show contact |
May 28, 2017, 5:26 am from: Morwakwena |
Am having a problem with the edu circuit malfunction code for Mark |
Contact: show contact |
May 28, 2017, 5:27 am from: Morwakwena |
Mark2 edu circuit malfunction code 1215 |
Contact: show contact |
July 25, 2017, 4:36 pm from: Sebastian |
I had the very same problem with my Toyota Mark 2, what it turned out to be was the V-Tec or VVTi solenoid was bad. After I changed it, the car drove well again. perhaps you could have the garage check it out. you can run a simple test by disconnecting the said solenoid and drive the car as is, it the car drive normally then that is a good indication that the solenoid may need replacing. |
Contact: show contact |
Updated on April 20, 2025